Circutor CVMk2 Series Manuel d'utilisateur télécharger pdf (Page 17)

CVM

INSTALLATION

As shown in the gure, the guide arrow should point

upward and line up with the arrow found on the rear of

the viewer or display screen. The arrow points to the

position where the RJ-45 communications cable and

the display screen power supply cables run out.

A zoomed view of the previous image is provided in the

figure. It provides a detailed view of the movements

necessary to lock and unlock CVMk2 display screen

mount ring.

The mount diagram is shown in the following gure. The measuring unit can then be mounted

on the ring behind the display screen, or it can be installed on a DIN rail and communicate

with the display screen via a communication cable and transparent RJ-45 power supply. (See

Table 3.1, physical description).

To install the screen in a panel as shows the 2.3 installations methods, you

have to use a at surface of a type 1 enclosure.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 151 152

Pas de commentaire

Circutor CVMk2 Series Manuel d'utilisateur Page 17