Circutor CEM-C10 series Manuel d'utilisateur télécharger pdf (Page 26)

4�7�8� Energy cost

NB: It is only displayed if the efciency factors display has been selected.

This is the home screen for entering the energy cost per kWh.

Long press the key to view the value to be programmed.

To write or modify the value, short press the key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit with a long press on

the key, allowing the remaining values to be modied.

To validate the data, move to the last digit and long press the key; the validation screen

will appear (Figure 11) indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 11 , the system returns to the Energy

cost programming main screen.

Minimum value: 0.000

Maximum value: 9999.999

Short press the key to access the next programming step.

4�7�9� CO

emissions

NB: It is only displayed if the efciency factors display has been selected.

This is the home screen for entering the ratio of the carbon

emissions.

The carbon emissions ratio is the amount of emissions released

into the atmosphere to produce a unit of electricity (1 kWh).

The European mix ratio is approximately 0.65 kgCo

per kWh.

Long press the key to view the value to be programmed.

CEM-C10

Instruction Manual

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Circutor CEM-C10 series Manuel d'utilisateur Page 26