Circutor CEM-C10 series Manuel d'utilisateur télécharger pdf (Page 9)

3.2.- INSTALLATION

On the side of the unit are all of the indications adjusted to the CEI 62052-11 standard.

The unit is installed on a DIN rail. All connections are located inside the electric panel.

Terminals, opening covers or removing elements can expose parts that are

hazardous to the touch while the unit is powered. Do not use the unit until it is

fully installed.

3.3.- UNIT TERMINALS

Table 3:List of CEM-C10 terminals�

Unit terminals

1 : L, Input, connected to the mains phase 6: LOAD, Output

3: LOAD, Output 21: impulse output (Collector)

4: N, Input, connected to neutral 22: Impulse output (Emitter)

Figure 1:Terminals of the CEM-C10�

Instruction Manual

CEM-C10

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 35 36

Pas de commentaire

Circutor CEM-C10 series Manuel d'utilisateur Page 9