Circutor CMBUS series Manuel d'utilisateur télécharger pdf (Page 14)

Figure 9:Selecting “Scan serial ports for device”�

10�- Once the COM port has been detected, you can add a CMBUS unit to the project by

clicking on the button to add units to the project as shown in Figure 10.

Figure 10: Button to add units to the project�

From the suggested units, select option:

- RESI-MBUS-MODBUS for the CMBUS-8 model and

- RESI-MBUS2-MODBUS for the CMBUS-24 model.

11�- Once the unit has been added, select it from the list of project units and congure the

communication parameters (Figure 11).

Figure 11: CMBUS conguration screen.

12�- Check the connection with the CMBUS by clicking on “TEST CONNECTION”

(Figure 11).

If the connection is successful, the CMBUS rmware version will appear on the screen in the

“Software version” eld along with the “State” of the unit at the time.

CMBUS

Instruction Manual

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Circutor CMBUS series Manuel d'utilisateur Page 14