Circutor CVM-C10 Series Manuel d'utilisateur télécharger pdf (Page 53)

 Programming the contact status

The status of relay contacts is selected on this screen.

Press key

for 3 seconds to edit the selection. The prog icon

will be displayed on the bottom of the screen.

Press key

to browse the two options:

Normally open contact.

Normally closed contact.

To validate the data, press for 3 seconds and the prog icon will disappear from the display.

Press key to access the next programming step

4�9�23� Programming alarm 2 (Relay 2)

The values for alarm relay 2 are programmed on this screen.

They are programmed as in the case of alarm relay 1, see

“4.9.22. Programming alarm 1 (Relay 1)”

4�9�24� Programming alarm 3 (Digital output T1)

All values for digital output T1 are programmed on this screen.

The variable code is selected on this screen, depending on Table

15,

which will control digital output T1.

Press key

for 3 seconds to edit the code selection. The prog

icon will be displayed on the bottom of the screen.

Press key for 3 seconds to edit the code selection. The prog icon will be displayed on the

bottom of the screen.

To enter or modify the value, press the key repeatedly, increasing the value of the ashing

digit.

When the desired value is shown on the screen, move onto the next digit by pressing the key

to modify the other values.

When you enter the code of a variable on the display, the symbols for that variable will be

activated.

Set the value to 00 if you do not wish to program a variable.

Instruction Manual

CVM-C10

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 81 82

Pas de commentaire

Circutor CVM-C10 Series Manuel d'utilisateur Page 53