Circutor CIRLAMP Series Manuel d'utilisateur Page 78

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 102
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 77
6�- CirLAMP Node 1 ��� 10V
6.1.- INSTALLATION OF THE UNIT
6�1�1� PRELIMINARY RECOMMENDATIONS
See section “4�1�1� PRELIMINARY RECOMMENDATIONS”�
6�1�2� INSTALLATION
Terminals, opening covers or removing elements can expose parts that are
hazardous to the touch while the unit is powered. Do not use the unit until it is
fully installed.
The unit has two cable seal/gland terminals (Figure 85):
Input for the power supply cables.
 Output towards the lamp and 1 to 10V output to control the ballasts.
The unit must be opened to complete the installation; to do this unscrew the four front screws.
Entrada alimentación
Input for power supply cables
Salida hacia la lámpara
Output towards the light
Tornillo
Screw
Figure 85:Position of the CirLAMP 1 to 10V cable seal terminals and screws
Connect the unit with 5 x 2.5 mm
2
hoses.
To pass the hoses through the cable seal terminals, which guarantees the IP65 protection de-
gree of the unit, you need to pierce the cable seal from outside of the box with a 3 mm
2
punch
( Figure 86)
78
CirLAMP system
Instruction Manual
Vue de la page 77
1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 101 102

Commentaires sur ces manuels

Pas de commentaire