Circutor computer PLUS-TF Series Manuel d'utilisateur télécharger pdf (Page 42)

Fig. 54.- Transformer Ratio Menu

Fig. 55.- Edit Transformer Ratio Menu

 Press Edit to adjust the desired value. To edit a field, follow the procedure described in section 5.4.

7.3.8 Adjusting the Tact and Trec times

The connection, disconnection and reclosing times between steps can be adjusted (reclosing means

connecting a previously connected step). To do so, follow this procedure:

 Open the setup menu by following the procedure described in section 7.3.2.

 Select the Tact, Trec option and press OK. The screen on Fig.57 will be displayed. In the quick

operation Computer plus units (TF-C and TF-CDI), the network cycle is the operating time adjustment

unit. 3 cycles have been adjusted in Fig.57).

 Press Edit to adjust the desired value, following an identical procedure to that described in section 5.4.

Fig. 56.- Tact, Trec Menu

Fig. 57.- Edit Tact, Trec Menu

7.3.9 Adjusting the compensation mode

Various parameters related to the compensation mode can be adjusted. To do so, follow this procedure:

 Open the setup menu by following the procedure described in section 7.3.2.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 68 69

Pas de commentaire

Circutor computer PLUS-TF Series Manuel d'utilisateur Page 42