Circutor computer PLUS-TF Series Manuel d'utilisateur télécharger pdf (Page 43)

 Select the Compensation (Fig.58) option and press OK The screen on Fig.59 will be displayed.

 Press Edit to adjust the desired parameter values.

Fig. 58.- Tact, Trec Menu

Fig. 59.- Edit Tact, Trec Menu

 The options available are:

In Comp … you can select three options TRIPH or PH-PH which means three-phase or Phase-

Phase compensation, respectively.

In Man … you can select the following options: FCP or LINIAL. These options are related to the

steps sequence in FIFO (FCP) or LIFO (LINIAL) mode. The FIFO mode means first in - first out

(disconnected) and the LINIAL mode means that the last one in is the first one disconnected.

In Contrl … you can select the following options: SEC or TOTAL. SEC means that there is a

sequential step input (one by one, respecting Tact). TOTAL means that all steps required to reach

the desired cos will be connected at once.

In Mode… you can choose between RUN or STOP, to start or stop Computer plus.

 To edit a field, follow the procedure described in section 5.4.

7.3.10 Adjusting the Date and Time

 Open the setup menu by following the procedure described in section 7.3.2.

 Select the Date / Time (Fig.60) option and press OK . The screen on Fig.61 will be displayed.

 Press Edit to adjust the desired day/month/year and hour:minute:second values.

 To edit a field, follow the procedure described in section 5.4.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 68 69

Pas de commentaire

Circutor computer PLUS-TF Series Manuel d'utilisateur Page 43