Circutor CVM144 Series Manuel d'utilisateur télécharger pdf (Page 34)

----- Supply network analyzer CVM-144 ------ User's manual --- Page No. 33

- For accessing to the next option, press " ": set-up options for the second

relay will appear.

OUT 2 RELAY 2

CODE

 Parameter value (2)

Act as before. Pressing again " " the set-up mode is exited.

b.- ALARM conditions (1 condition for each relay): If any other parameter (excepts

for energies) is selected at (1), two outputs can be configured as alarms. For each

output it is possible to set:

 Any of the parameters measured by the CVM-144

 MAXIMUM value

 MINIMUM value

 Delay for the conditions

These screens are successively displayed by the CVM-144 once the

parameter has been selected ( for the set-up of each option proceed as in the

Section a.-):

b.1.- Programming the maximum value to be controlled:

OUT 1 RELAY 1

AL hI

0.000

 Maximum value

The key "max" will increase the value of the blinking digit (0,1...9, sign -- ).

Use the key "min" to pass to the following digit.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 57 58

Pas de commentaire

Circutor CVM144 Series Manuel d'utilisateur Page 34