Circutor DHB Series Manuel d'utilisateur télécharger pdf (Page 17)

Value Change Way of the Chosen Parameter

Change of Integral Values

In order to increase the value of the chosen parameter, one must

press the buton. The single pressure of the button, causes

the increase of the value of 1. The holding down of the button

causes a continuous increase of the value on the given digit. The increase

of value when displaying the digit 9 causes the setting of 0 on this digit.

The change of the digit follows after pressing the button.

In order to accept the set parameter, one must hold down the

button. Then, the saving of the parameter follows and the display of its

symbol alternately with the new value. The pressure of the but-

ton during the change of the parameter value will cause the resignation

of the write.

Changing of Values

The change is carried out in three stages (the transition to the next

stage follows after pressing the button:

1) setting the value from the range -19999M...99999M, similarly as for

integral values;

2) setting of the decimal point position (00000., 0000.0, 000.00,

00.000, 0.0000); the button shifts the decimal point to the

left, however the button shifts the decimal point to the right;

3) choice of the prefix: lack, k, M; the button switches the next

prefix; the chosen prefix is displayed in orange.

The pressure of the button during the change of the parameter

value will cause the resignation of the saving.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 53 54

Pas de commentaire

Circutor DHB Series Manuel d'utilisateur Page 17