Circutor DHB Series Manuel d'utilisateur télécharger pdf (Page 13)

Þ moving through the menu – choice of level,

Þ entry in the mode changing the parameter value,

Þ acceptation of the changed parameter value,

Þ stop the measurement – when holding down the button, the result

on the display is not updated.

The measurement is still carried out.

- button increasing the value:

Þ display of maximal value, The pressure of the button causes the

display of the maximal value during ca 3 seconds,

Þ entry in the level of the parameter group,

Þ moving through the selected level,

Þ change of the selected parameter value – increasing the value.

- button changing the digit:

Þ display of minimal value, The pressure of the button causes the

display of the minimal value during ca 3 seconds,

Þ entry in the level of parameter group,

Þ moving through the selected level,

Þ change of selected parameter value – shift on the next digit,

- resignation button:

Þ entry in the menu monitoring the meter parameters (by holding

down ca 3 seconds),

Þ exit from the menu monitoring meter parameters,

Þ resignation of the parameter change,

Þ absolute exit from the programming mode (holding down

ca 3 seconds).

The pressure of the button combination and holding

them down ca 3 seconds causes the erasing of alarm signaling. This

operation acts only when the support function is switched on.

The pressure of the button combination causes the era-

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 57 58

Pas de commentaire

Circutor DHB Series Manuel d'utilisateur Page 13