Circutor DHB Series Manuel d'utilisateur télécharger pdf (Page 50)

7. ERROR CODES

After switching the meter on or during the work, messages about errors

can appear.

Messages about errors and their reasons are presented below.

Error message Description

Overflow of upper value of the measuring range value or

the programmed indication range

Overflow of lower value of the measuring range value or

the programmed indication range

ErFrt

Communication error with the data memory. One must

contact the service workshop.

ErPar

Parameter error. Wrong configuration data.

Manufacturer’s settings will be restored after pressing any

button.

ErdEF

Default settings have been restored. One must press any

push-button to transit to a normal work.

ErFPL

Error of measured values stored by the meter (measured

value, maximal value, minimal value). One must press any

push-button to transit to the normal work. After pressing

the push-button, the ErdEF message will be displayed

during one second.

ErCAo

Error of analog output calibration. One must press any

push-button to transit to the normal mode. Analog outputs

will not be serviced. One must contact the Service

Department.

Table 14

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 56 57 58

Pas de commentaire

Circutor DHB Series Manuel d'utilisateur Page 50